This video is a spirited drive in the Texas Hill Country.  I'm not pushing it very hard because there are frequent bicyclists that travel the road and could be just around the blind curves.

This video is a casual stroll through on the same road as above and was a proof of concept measuring engine and sensor parameters using National Instruments cRIO hardware, LabVIEW, LabVIEW FPGA, LabVIEW Real Time, and Vision to display the measurements next to the video.  Some of the sensors weren't calibrated as this was only a proof of concept and I didn't have time to finish it out.  All measurements were taken using analog measurements since the spyder, even in stock configuration doesn't have CAN.  There is a way to access the APEXi ECM through a serial port but that requires a bit of programming that I haven't had time to learn.  There are many leaders on Spyderchat that have some really good applications that do this so hit the boards!

This could be the sound your Spyder makes if you buy it from me!

Acceleration- 0-60mph: estimated Fives, 0-100mph: estimated Twelves.